We recommend 4 lines of Cameo™ and 2 lines of Cameo Pulse™ on posts spaced 12’ apart. Our Cameo Pulse™ looks like another line of Cameo from a distance of approximately 10ft, providing a clean looking fence.  The result is a fence that is always working, it has the strength to contain your horses and the electric to teach them to respect the fence. 

For Corner, End, and Gate post a 5” or 6” in diameter x 8’ round pressure treated post is recommended. 

For Line post we recommend 4" x 6' 6" round pressure treated wood posts. However, vinyl, metal or PVC work as well. 

***Our brochure provides a simple image of what this set up looks like. Click here to view the brochure! Note: Maxi-Grunt has changed names, it is not Cameo Pulse. 

Cameo is held at the end and gate post using a One-Way Vise.

            - Drill the end and gate post with a 3/4” drill bit where the Cameo™ lines will go.

            - Push the Cameo through the hole.

            -Slip on the One-way vise onto the Cameo™. The jaw system automatically grips the Cameo™ line, preventing the line from slipping back.

            -Drill 7/16” hole about 3 inches into corner and end post where the electric line will go.

            -Screw in End/Gate post insulator.

            -Wrap Cameo Pulse around insulator and secure with 2 Electric Connectors.

***Our brochure provides a simple image of what this set up looks like. Click here to view the brochure! 

CORNER POST use the same Corner Post Insulator for both Cameo™ and Cameo Pulse™

            -Screw CORNER POST INSULATOR onto Corner post

LINE POSTS also use the same Line Post Insulators for Cameo™ and Cameo Pulse

            -Install line post brackets

After running all your lines of CAMEO™ and MAXI GRUNT, pull CAMEO™ hand tight through the one way vise at the end and gate post.  Then pull an additional 3% of line through the one way vise.  This assures proper tension on the line.  For Cameo Pulse pull hand tight.  Do not over stretch the electric line, pull just enough that there are no “bellies” between line post. 

Setting Up Cameo Pulse and Charger: 

***NOTE: these instructions suit our Cyclops A/C Charger, if you purchased a different charger, refer it's instructions for connections as well.

Find a dry location to mount your charger. Do not plug charger in until everything else is complete. 

1. Attach Underground Wire to black knob on Cyclops Charger  and run down to the three Ground rods, each spaced 6'-10' apart. 

2. Remove a small section of plastic wire coating from the underground wire and attach to each ground rod using Ground Rod Clamps. 

3. Attach a second piece of underground wire to red knob on charger. Run this wire to Cameo Pulse (removing a small section of plastic wire coating) at each hot line of your fence.  Affix to Cameo Pulse with U-Clamps.  

4.  Assure all connections are tight. 

5. Plug charger into a 110v outlet. 

***To view more detailed/printable electric installation instructions click here!

***Our brochure provides a simple image of what this set up looks like. Click here to view the brochure!  Note: Maxi-Grunt has been renamed to Cameo Pulse.